Assemblies and motion
Place components, join them, drive the mechanism and check that it moves.
Components
An assembly is a set of components placed by joints. Bodies can live at the top level while you model a single part, but a mechanism needs its moving parts in components.
- Create a component in Assemble › Component, then move bodies into it.
- One occurrence of the base component is grounded (fixed in space). Everything else is positioned by joints.
- A component's radio button in the Browser makes it the active component; new bodies go there.
- Move and rotate components freely before joining them; Joint as built keeps parts where they are when you add a joint.
Joints
Joints define how parts move relative to each other. Each joint takes two occurrences and an origin: a point and a Z axis. Values and limits are degrees for angles and millimetres for distances.
| Type | Motion |
|---|---|
| Fixed | No relative motion. |
| Revolute / hinge | Rotation about one axis, with optional angle limits. |
| Slider | Translation along one axis, with optional distance limits. |
| Cylindrical | Rotation and translation on the same axis. |
Every chain must reach something grounded. A part that is neither grounded nor joined to a grounded part cannot be placed, and a drive on that chain moves nothing.
Flip matters when both joint origins sit at the same point and axis: without it, the second part turns 180°. Use Joint as built when parts are already in place.
Linked motion
Motion links drive one joint from another, which is how gears, racks, screws and cams are modelled without keying every part:
- Gear: two joints turn at a ratio taken from their radii.
- Rack and pinion: the rack moves by radius × angle.
- Screw: translation per turn from the thread pitch.
- Cam: a follower rides a cam profile, as a knife, roller or flat follower.
Chains work in any creation order. Drive the head of the chain and the rest follows; drive only one end, never both.
Contact and closed loops
Contact sets stop a study where two bodies would pass through each other. Closed loops — an actuator pushing a hinged panel, a four-bar linkage — are built from three joints: a root pin, a slider with the stroke as its limits, and a tip pin that closes the loop. Drive the hinge and the pins and slider follow.
Motion studies
A motion study keys the driving joints over a number of steps:
- Choose the study steps and key joint values at points along it. Values are linear between keys.
- Play the study to see the poses; playing does not change the saved design.
- Export the poses for analysis, or export an animated GIF of the whole motion.
Use Interference to check what collides during the motion, and Sweep to find how far a hinge or door opens before something touches. A trace records the path of a point on a moving part as a 3D sketch spline.
Checks before you save
- Degrees of freedom: the joint list reports the remaining freedom per occurrence. A floating part has six.
- Conflicts: a loop that cannot close is listed, and nothing in it moves.
- Values: read back the joint values after a drive and compare them with the geometry you expected.
- Interference: run it at several points in the motion, not only at the start and end.
Exploded views
Explode creates a presentation state of the assembly, moving parts outward along a scale you choose. Exploded views can be used in the storyboard and in drawings, and do not change the assembled positions.